All Collections
Socket 7mi Scanner Redundancy Set-Up
Socket 7mi Scanner Redundancy Set-Up
Written by Matt Panton
Updated over a week ago

It's possible for a barcode scanner to read the wrong barcode number when scanning a heat seal barcode, especially if the barcode is faded or warped. In order to prevent barcodes from being read incorrectly, you can activate the Redundancy setting on your Socket 7mi scanners. This makes the scanner read the barcode a set number of times in order to make sure that each scan is identical. To enable this setting, print out this page and scan the following barcode:

After you have scanned the barcode above, re-start your scanner before using.

Did this answer your question?